A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time. NOTE: In the Start Times dial position, the numbers 1-4 do not represent stations.
Correspondingly, How do you repair a hunter valve?
What do you do when your sprinklers won’t turn off?
Furthermore, Why are my sprinklers still running when turned off?
There are two reasons why your sprinklers would continue running: It is possible that your valves have been opened manually. You will need to locate your valve box(es) and twist the solenoid(s) on the valves clockwise until snug.
Why is my Hunter irrigation system not working?
The most common reason your sprinklers are not watering is because the rain sensor is active. Do you have a rain sensor on your sprinkler system? If so, slide your sensor bypass switch into the « BYPASS » position (on an SRC, turn the dial into the RUN (Bypass Sensor position).
How do you test a hunter solenoid valve?
How do you replace a hunter irrigation valve?
How do you install a hunter valve?
Should solenoid be on or off?
Avoid over-turning the solenoid in either direction, as this can cause damage to the components or cause pressurised water to escape the solenoid. When you hear water rush through the device, it’s easy to tell that the valve has opened successfully.
How do I find my sprinkler shut off valve?
Where is my sprinkler water shut off?
Should sprinkler valves be on or off? Make sure the sprinkler valve is closed, unless it’s the valve farthest from the main water source. You’ll want to leave this valve open and remove the sprinkler nozzle to allow air to escape when you turn on the water.
How do you turn off a hunter irrigation system?
To turn the controller back on, use the center button to return to the home screen and allow the controller to go to sleep in that position. To turn your controller off, press the button until the icon and Off is displayed on screen.
How do I turn on my hunter irrigation system?
How do I test my Hunter Pro C sprinkler system? To initiate the test program:
- Press and hold the PRG button. The station number will be flashing.
- Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes. …
- After a 2 second pause, the test program will begin.
How do you fix a sprinkler valve that won’t turn on?
How do you turn off a Hunter valve?
How do you open a solenoid valve manually?
How do you clean Hunter irrigation valves?
How do you change a hunter solenoid valve?
How do you install a hunter solenoid valve?
